I'm just replacing the pads both sides at the rear of my 850 and cannot find the replacement torque settings for the two bolts on each caliper on replacement. I think the reference number is: 34 21 5AZ
Any ideas anyone?
Thanks
Bob
850CI
Torques settings - rear brake calipers
-
-
Rear brakes all completed. Interestingly they are not bolts but Allen screws (7mm head) Just tightened them up as tight as felt correct. I didn't realise that the brake wear sensors are on one side only front and back and are diametrically opposite each other. Rear nearside, front offside.
First oil and filter change for me today to fully synthetic. Old oil was black! One thing I did find when undoing the filter housing that both filter housing rubber mounts had completely sheared. Would never have spotted this as all looks correct from the top. On starting now, oil pressure light goes out immediately, this was not the case before (2-5 seconds).
Also found a joint that needs replacing on the front suspension which probably solves the wheel shake.
Good work, no alarms up and drives great, have a good weekend.
Bob
-
Good work
whenever I work on the car I always come up against the dreaded "the nut/bolt that won't come undone"
-
Zitat von Bob Beebe;89561
...filter housing rubber mounts had completely sheared...
Very common problem. Cheap and easy to replace though.
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!