Hello all,
while helping my friend Kevin McIntyre of K-Mac suspension at the SEMA show here in LAs Vegas I learned a few things that some of you have asked before so I thought I should share them with you.
The new K-Mac Camber/Caster kits for 8 Series are available in two styles.
The 192216-2 (Stage 2_has a urethane encased "Pillow Ball" bearing (the early style was a conventional ball race) which gives a softer ride than the 192216-3 (stage 3) which does not have urethane.
Unlike the old style all steel kits you would need to use a measure tape to see the 2-3mm hight increase whereas the old style was clearly visible.
The new kits go more than 2 degrees out of the box and can be further opened out to get up to 3.5 degree negative if desired.
Their website is http://www.k-mac.com
cheers
