As posted yesterday, I'm sending the Alpina for paint this week. Does anyone know how to remove the washer filler cap on the right side of the back - under the trunk lid above the bumper? I have not seen one on a US car, but have on non-US cars.
Here is a picture. The cap I am referring to is just to the left and below the right rear lights.
Help Getting Cap Off
-
-
On a previous 840 I replaced this cap,old one was in poor shape, it just pulled off so easily other than that can't add further
-
I might be wrong but I think this only comes on vehicles fitted with headlight cleaning. To the best of my knowledge it is simply a plug type fixing that pops out and contains a fine mesh filter.
Good luck with the project!
Cheers
Graham -
Rigt I've done this a couple of times....
You need to remove the trunk finisher piece along the back inside the trunk...
My filler cap/neck was held onto the rubber hose by a cable tie, cut it and then it should push up and out. `don't pull the flap it will break.....
Fitting back can be a bitch so have a practice before it's got it's new paint on!!!Alex
-
Whats a doug nut Schnitz?
-
It's a bit like a wingnut!! but not as friendly... LOL I'm a dick......
Doughnut !!!!
I'm going away now....
-
I did try and delete my post as after reading it again, it wasn't in the slightest amusing. Sadly I couldn't see how to delete so I expect I'll get a punch in the chops at some meeting this year!
-
Zitat von sandwich;97018
I did try and delete my post as after reading it again, it wasn't in the slightest amusing. Sadly I couldn't see how to delete so I expect I'll get a punch in the chops at some meeting this year!
Hay...as long as we all have funno problem.
Thanks everyone for the tips.
-
Got it out last night...thanks for all the advice.
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!