Hi.
Please can someone give me the torque settings for the head bolts on the m70 V12 Engine eg torque n/m and degrees and stand time.
Regards
Chris
Hi.
Please can someone give me the torque settings for the head bolts on the m70 V12 Engine eg torque n/m and degrees and stand time.
Regards
Chris
Chris, have got an Autodata printout for this which gives the following:-
Stage 1 Tighten 30Nm
Stage 2 Wait 15min
Stage 3 Tighten 120deg
Although this is not a BMW document, the info should be correct.
Hope this is of help to you.
John.
torque settings
Hi John.
Thanks very much for rapid postings of reply ref head torquing.
Is there any specific sequence to torquing !!
Thanks in advance
Regards
Chris
How did I know that you would ask this question??? I must be psychic!!!
Unfortunately I don't have the correct software to reproduce the Autodata pic on here as I am sure other 8 fans would be interested in this.
However, I will scan said document and get it in the post to you via e.mail since you have provided your address it in your profile.
Happy torqueing!
John.
Tightening Values Headbolts:
1.stage: 30NM
2.stage: 60* angle
3.stage: 60* angle
Thanks for that.
Have got car back together again now after head rebuild and i am having trouble with the cooling system pressuring up.
Both heads were skimmed and we took great care in re assembling.
Any body any ideas.
Water pump, thermostat and rad are ok.
Thanks in advance.
Chris
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!