I've been having this issue for a while, but had it on my "to-do" list of future projects.
My roof is not working properly, it's out of sync or something.
Happened after the car sat with drained batteries for a while.
1. it slides too far rear and disappears into the cars roof.
2. when closing, it stops with a 4-5cm gap remaining.
3. to close the gap I have to give the tilt command, roof now closes.
4. as the roof is now closed after the tilt command is given, it will not tilt any further.
If I press the open command (switch forward), it will open to the same 4-5cm gap.
I have tried to reset the roof by removing disconnecting the command switch, and then give the tilt command for 10 seconds. did not help.
the reason it has been on my list for a while is that the roof liner around it has started to come lose, and I was planning of re-doing the liner, however this is also dragging out in time, so i thought I better get the roof fixed for this season.
Any thoughts on how to reset, or do I have to try and pull it out and rebuild it?