Today I finally managed to complete the service on the hydraulic system after replacing all fluids , replacing and cleaning all filters . replacing leaky hoses and so on.
Time to test the system 
First running Dynamic actuator test ( fast full movement ) , then load test a 65 sec test to bleed the system after filter fluid replacment in the hydraulic system.
cool and well done! Nice job!
That really is classy - just streets ahead of its time.
Don´t play with it too often just for the fun of it. The forces required to move a standing wheel will be a lot higher than wenn rolling. Not unlike trying to steer a standing car. For this test procedure IIRC it is advised to lift the rear axle.
Cheers
Reinhard
Yes i have heard the same 
but the diagnose said to keep the wheels on grond and make shure the car could move.
Freely. Still i think you are correct it should not be to often but its just to cool so it will be difficult 
Hi Huldra, can you please tell me what software and interface you are using, ''GT1.?'' I am slowly geting to the phase when I will need this to see if every thing is doing what it should.
Its ok figured it out my self..! thanks any way. Ciao.
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!
