Today I finally got round to fitting this kit and all I can say is WOW , they look stunning, (only one minor problem but will be an easy fix, see below) just have to sort out the side lights as they look mega yellow now, so what my plan is to get some bulbs for the side lights and if I can get some for the reversing lights, but that will have to wait for the weekend.
Les (and anyone else), hope this helps with your installation of the HID kit.
So firstly I removed the old bulbs and installed the new ones (just remeber DONT touch them with your fingers) I used a clean cloth just to be extra carefull.
Second job was to take the screws and bolts out from the top half of the lights (gives you extra room to move) so you are able to tilt them forward as I wanted to mount the ballasts under the bracket that the lights sit in and I also wanted to bring the wires through the hole that is there under the bottom of the lights.
So now I have the lights on (so they are tilt up at this point I went ahead and fitted the ballasts and sort out the wires to the bulbs,
Now you have the wires in place you can go ahead and fit the harness, (I did not use the plug and play I used the spades), I found this the hardest job (purely beacuse of the small length of wire they give you to connect to the battery terminal and fit to the ballasts etc), so I connected the postive to the + terminal in engine (removed the lower cover of the terminal and fitted it down there), then its just a case of securing the negative, just make sure you have a good, tight connection on both.
So then I finished by double checking every connection was tight and secure and wrapping every connection with insulation tape.
Then I fired them up, left them for 15 minutes to burn in and then fitted the covers, etc back and there you go, ok not as quick as an auto electrican but at least I got my hands dirty and i'm also starting to learn how my baby works.
So about this minor fault, on the OBC it comes up with "Low Beam Failure", so I have spoken to a garage, they have said it will just the case of fitting a risister, not a big job, hopefully will be sorted in a few days.
Hope this helps, if anyone requires any other information, just ask.
Cheers
Wayne
P.S Thanks alex for this bargain